Reply to thread

Message

<blockquote data-quote="Kaisershmarren" data-source="post: 691455" data-attributes="member: 20883">Good afternoom,I've a problem with TV Server configured in Multi seat mode.My configuration is set as follows:&nbsp;1) TV Server 1.1.0 with Power Scheduler plugin enabled. The power scheduler is set to go on hibernation after 10 minutes. It is also enabled the network control for a traffic of 2kb.2) three MP Clients 1.1.0 pointing to TV-Server, each one with the power scheduler plugin enabled and set to 10 minutes. I also enabled the wake-up on lan option in the TV Section.3) two NAS for video sharing.4) Each piece communicate to each other through an 8 port Gigabit eth switch.What's happening is the following.1) Switch-on an MP Client. The MP Client starts correctly.2) TV server starts&nbsp; correctly (as he receives the wake on lan packet from the MP Client)3) On MP Client, I select the TV and watch TV for some minutes. Everything goes OK4) On MP Client, I stop the TV and select something other (e.g. pictures, music).5) After 10 minutes TV Server goes on hibernation. On MP Client appears a warning the TV Server is no more active.6) On MP Client I select again TV, but the TV-Server does not start again.To solve this, I've to:1) Close and restart MP Client or2) Switch on manually the TV-ServerIs there a way to make the TV SErver wake-up again automatically?Thanks a lot.</blockquote>

[QUOTE="Kaisershmarren, post: 691455, member: 20883"] Good afternoom, I've a problem with TV Server configured in Multi seat mode. My configuration is set as follows: 1) TV Server 1.1.0 with Power Scheduler plugin enabled. The power scheduler is set to go on hibernation after 10 minutes. It is also enabled the network control for a traffic of 2kb. 2) three MP Clients 1.1.0 pointing to TV-Server, each one with the power scheduler plugin enabled and set to 10 minutes. I also enabled the wake-up on lan option in the TV Section. 3) two NAS for video sharing. 4) Each piece communicate to each other through an 8 port Gigabit eth switch. What's happening is the following. 1) Switch-on an MP Client. The MP Client starts correctly. 2) TV server starts correctly (as he receives the wake on lan packet from the MP Client) 3) On MP Client, I select the TV and watch TV for some minutes. Everything goes OK 4) On MP Client, I stop the TV and select something other (e.g. pictures, music). 5) After 10 minutes TV Server goes on hibernation. On MP Client appears a warning the TV Server is no more active. 6) On MP Client I select again TV, but the TV-Server does not start again. To solve this, I've to: 1) Close and restart MP Client or 2) Switch on manually the TV-Server Is there a way to make the TV SErver wake-up again automatically? Thanks a lot. [/QUOTE]

Verification