Reply to thread

Message

<blockquote data-quote="Teflon4" data-source="post: 427381" data-attributes="member: 92327">Just registered on here to add my voice to the people who are having this problem.I have an Antec Micro Fusion 350 case with the iMon LCD/remoe combo and a Harmony One remote.I switched iMon to MCE remote mode as the Harmony has issues emulating the iMon PAD remote.Everything works fine until I enable MiniDisplay, at which point as soon as MP fires up and the LCD comes on the remote stops working.Even after I close MP, the remote won't function. The only way I can get it to function again is to open iMon, frontview settings, change it to &quot;Always&quot; press apply and then back to &quot;Never&quot; and hit OK. The remote is back working again until I start MP again.From what I can see, both the IR and the LCD are controlled from a Cypress CY7C63743 microcontroller running soundgraphs firmware. I'm thinking that MiniDisplay is sending a code that disables MCE mode either due to an iMon firmware bug or a MiniDisplay bug. Are the HID codes sent and what they do documented enywhere?iMON firmware ver 0x380102 LCD HID OEMP</blockquote>

[QUOTE="Teflon4, post: 427381, member: 92327"] Just registered on here to add my voice to the people who are having this problem. I have an Antec Micro Fusion 350 case with the iMon LCD/remoe combo and a Harmony One remote. I switched iMon to MCE remote mode as the Harmony has issues emulating the iMon PAD remote. Everything works fine until I enable MiniDisplay, at which point as soon as MP fires up and the LCD comes on the remote stops working. Even after I close MP, the remote won't function. The only way I can get it to function again is to open iMon, frontview settings, change it to "Always" press apply and then back to "Never" and hit OK. The remote is back working again until I start MP again. From what I can see, both the IR and the LCD are controlled from a Cypress CY7C63743 microcontroller running soundgraphs firmware. I'm thinking that MiniDisplay is sending a code that disables MCE mode either due to an iMon firmware bug or a MiniDisplay bug. Are the HID codes sent and what they do documented enywhere? iMON firmware ver 0x380102 LCD HID OEM P [/QUOTE]

Verification