Reply to thread

Message

<blockquote data-quote="chesh" data-source="post: 380294" data-attributes="member: 88249"><p>Ok guys, I'm back.&nbsp; I had my first HD-PVR go bad on me and I just got my replacement the other day.&nbsp; Just did a full reinstall of the TV3 server cause the old HD-PVR was still showing up and the new one was in there too....anyway, long story short, I finally got it set back up again.&nbsp; My schedulesdirect is working (Thanks WileECoyote for your suggestion on that one) and I got the Hauppauge IR Blaster working using the modified Serverblaster from another thread.&nbsp; I'm able to preview, etc in the TV Server Config screens, but when I load up MP and goto My TV, the TV initially starts on (I've tried this both ways), but nothing is being displayed.&nbsp; If I try to switch channels, I see the IR Blaster change the channel, but then MP hangs.&nbsp; It seriously goes to 50% CPU utilization and I have to ctrl-alt-del it to shut it down.&nbsp; I can't for the life of me figure this out.&nbsp; I'm not seeing anything special in the logs to point me in a specific direction.&nbsp; I've even tried My TV in both Blue3 and StreamedMP and I get the same result both times.&nbsp; Any ideas of why this might be happening?? Thanks to all of you.</p></blockquote><p></p>

[QUOTE="chesh, post: 380294, member: 88249"] Ok guys, I'm back. I had my first HD-PVR go bad on me and I just got my replacement the other day. Just did a full reinstall of the TV3 server cause the old HD-PVR was still showing up and the new one was in there too....anyway, long story short, I finally got it set back up again. My schedulesdirect is working (Thanks WileECoyote for your suggestion on that one) and I got the Hauppauge IR Blaster working using the modified Serverblaster from another thread. I'm able to preview, etc in the TV Server Config screens, but when I load up MP and goto My TV, the TV initially starts on (I've tried this both ways), but nothing is being displayed. If I try to switch channels, I see the IR Blaster change the channel, but then MP hangs. It seriously goes to 50% CPU utilization and I have to ctrl-alt-del it to shut it down. I can't for the life of me figure this out. I'm not seeing anything special in the logs to point me in a specific direction. I've even tried My TV in both Blue3 and StreamedMP and I get the same result both times. Any ideas of why this might be happening?? Thanks to all of you. [/QUOTE]

Verification