Reply to thread

Message

<blockquote data-quote="ixian" data-source="post: 382662" data-attributes="member: 54932">I tried again, after doing a complete cleanup of Mediaportal/TVServer.I installed the SVNs from the first post, then the SchedulesDirect plugin, then the Hauppage blaster replacement plugin mentioned earlier in this thread.I configured the TVServer, it saw my HD-PVR as an analog device. I configured my SchedulesDirect plugin with my account information and downloaded my channnels/EPG, restarting the config/TV Service while doing so.I then went in to TVServer config and mapped my channels to the HD-PVR. I noticed that by default they are set to &quot;S-Video&quot; when I believe they should be set to &quot;RGB 1&quot; since I am using the component inputs - have no idea if this makes a difference or not since I haven't seen it mentioned in here before.In the channel mapping section if I select to test view a channel there's a 6-7 second delay and then a little window pops up that shows the channel - it moves for a moment then settles on a still image.I then configure the MP Client, pointing it at the ip of my tv server, configure codecs for the tv client (Arcsoft, as shown earlier in this thread. I start MP using the default Blue3 Wide skin with no additional plugins/addons.And after that, I end up with the same issue. I can view the program guide and the EPG is populated with the right channels and program info. If I try to turn &quot;on&quot; the TV it pauses for about 10-15 seconds, then tells me &quot;Connection to TV Server lost&quot;.I've attached the logs from the fresh install I did. Obviously I am still doing something wrong - any ideas?</blockquote>

[QUOTE="ixian, post: 382662, member: 54932"] I tried again, after doing a complete cleanup of Mediaportal/TVServer. I installed the SVNs from the first post, then the SchedulesDirect plugin, then the Hauppage blaster replacement plugin mentioned earlier in this thread. I configured the TVServer, it saw my HD-PVR as an analog device. I configured my SchedulesDirect plugin with my account information and downloaded my channnels/EPG, restarting the config/TV Service while doing so. I then went in to TVServer config and mapped my channels to the HD-PVR. I noticed that by default they are set to "S-Video" when I believe they should be set to "RGB 1" since I am using the component inputs - have no idea if this makes a difference or not since I haven't seen it mentioned in here before. In the channel mapping section if I select to test view a channel there's a 6-7 second delay and then a little window pops up that shows the channel - it moves for a moment then settles on a still image. I then configure the MP Client, pointing it at the ip of my tv server, configure codecs for the tv client (Arcsoft, as shown earlier in this thread. I start MP using the default Blue3 Wide skin with no additional plugins/addons. And after that, I end up with the same issue. I can view the program guide and the EPG is populated with the right channels and program info. If I try to turn "on" the TV it pauses for about 10-15 seconds, then tells me "Connection to TV Server lost". I've attached the logs from the fresh install I did. Obviously I am still doing something wrong - any ideas? [/QUOTE]

Verification