Reply to thread

Message

<blockquote data-quote="rojoyinc" data-source="post: 700707" data-attributes="member: 109509">MM- thanks - (oh there they are yeah - I see the names are less formal for the logos.&nbsp; Will change them to match!Re: Glitching. (I don't get this with the included arcsoft viewer.&nbsp; Did get it with MP until just recently.IR commands&nbsp;&nbsp; -&nbsp; I have it sending all the channel change. I'm using the default (included) STB / 301 model I think...&nbsp; (quick setup) all those worked.I then recorded&nbsp; SELECT and&nbsp; &quot;RECALL&quot; channel.&nbsp; I added those to my&nbsp; STB listings and even in&nbsp; &quot;TEST&quot; they don't seem to work.String - I'm all for it (yes please send it) and how to call it.&nbsp; I think the standby mode seems to be every 3-4 hours.&nbsp; On my old SD dish was 24 hours and wasn't a problem. I'd attach a &quot;select&quot; (enter) on the end of a channel change and do a manual 2 minute record at 5am which would reset the screen saver mode.&nbsp;&nbsp; Not working with newer HD receiver.Else if I could send a PREFIX (precode - I think is in the default IR's I loaded) I could send a SELECT before each channel change which should wake up the receiver.(there doesn't appear to be a precode loaded) in the&nbsp; quick setup&nbsp; STB / dish301 codes.I'm using TV3.</blockquote>

[QUOTE="rojoyinc, post: 700707, member: 109509"] MM- thanks - (oh there they are yeah - I see the names are less formal for the logos. Will change them to match! Re: Glitching. (I don't get this with the included arcsoft viewer. Did get it with MP until just recently. IR commands - I have it sending all the channel change. I'm using the default (included) STB / 301 model I think... (quick setup) all those worked. I then recorded SELECT and "RECALL" channel. I added those to my STB listings and even in "TEST" they don't seem to work. String - I'm all for it (yes please send it) and how to call it. I think the standby mode seems to be every 3-4 hours. On my old SD dish was 24 hours and wasn't a problem. I'd attach a "select" (enter) on the end of a channel change and do a manual 2 minute record at 5am which would reset the screen saver mode. Not working with newer HD receiver. Else if I could send a PREFIX (precode - I think is in the default IR's I loaded) I could send a SELECT before each channel change which should wake up the receiver. (there doesn't appear to be a precode loaded) in the quick setup STB / dish301 codes. I'm using TV3. [/QUOTE]

Verification