Installed MP 02. MP shutdown after settings(solved) (1 Viewer)

[thedge]

Area: Media Portal Program
MediaPortal Version: 0.2.0.0 (2006-07-03)
MediaPortal Skin: BlueTwo
Windows Version: Windows XP (SP2)
.NET CLR Version: 2.0.50727
DirectX Version: 4.09.00.0904 (9.0c)
Audio Codec: DScaler Audio Decoder
Video Codec: DScaler Mpeg2 Video Decoder
CPU Type: AMD Athlon XP 2400+
Memory: 1 GB
Motherboard: nVidia-nForce2 (Gigabyte Technology Co., Ltd.)
TV Card Model: fusion hdtv dual tuner
TV Card Type: DVB
TV Card Driver: 4.0.102
Video Card Model: Nvidia Geforce FX 5200 (microsoft Corporation) (128 MB)
Video Card Driver: 5.37
Video Card Resolution: 1024x768
Video Render Type: -
Audio Card Model: Realtek AC'97 Audio
Audio Card Driver: -
Synopsis::

I have just installed MP 02 on my comp. Went into settings and when I selected scan sydney area for signals. I got the 'MP.EXE has encounted a problem and needs to close' message.

 

[Callifo]

Dont use the wizard, if you quit just before the point where it crashes and run Setup again it should allow you into the configuration program. Setting it up from there shouldnt produce the same error.

 

[thedge]

scanning channel problem

Hi Callifo,
The wizard is the only way to scan for channels. It worked ok in the last version. I tried as you suggest but couldn't get any channels.
many thanks

 

[tourettes]

Re: scanning channel problem

Hi Callifo,
The wizard is the only way to scan for channels. It worked ok in the last version. I tried as you suggest but couldn't get any channels.
many thanks

It's also possible to scan channels from configure. Autoscan is locate some where under the tv cards config, can't remember the exact place.

 

[thedge]

scanning channel problem

Hi,
What I have tried:
Enter mediaportal/settings/setup wiz/language-country
setup general/ remote selected /cards detected/press next to config cards.
tv set- DVB Terrestrial/ select sydney/ scan/ no channels found than message' MP encounted a problem and needs to close'
many thanks

 

[ronilse]

Hi,
The safe way to scan for channels it's in MP Setup (configuration) -> Television -> Capture Cards -> your card & edit -> Autotune.

Regards
Roy

 

[thedge]

scanning tv problem

HI Ronilse
I have scanned the channels and they are fine.
many thanks