home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Input / Output interfaces
Remotes
IR has stopped working
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rsbrux" data-source="post: 1283178" data-attributes="member: 49539"><p>Thanks, but I already tried that. The first 12 "IrDeviceV2" entries produced no messages at all. The last 2 (labelled "Mouse") produced messages at a rate which caused the HID Demo UI to become unresponsive. The only possible source for these messages was the RF remote I was using to operate the HID Demo UI. Why should an RF device appear under this device ID, and why should the IR devices I was looking for appear under the same device ID? It would be easier if I could decouple the operation of the HID Demo UI from the signals to be examined, but that will be difficult if they are consolidated under some other, composite or virtual, device. I tried running HID Demo from a Remote Desktop session, but then it didn't see any devices at all. Any other suggestions?</p></blockquote><p></p>
[QUOTE="rsbrux, post: 1283178, member: 49539"] Thanks, but I already tried that. The first 12 "IrDeviceV2" entries produced no messages at all. The last 2 (labelled "Mouse") produced messages at a rate which caused the HID Demo UI to become unresponsive. The only possible source for these messages was the RF remote I was using to operate the HID Demo UI. Why should an RF device appear under this device ID, and why should the IR devices I was looking for appear under the same device ID? It would be easier if I could decouple the operation of the HID Demo UI from the signals to be examined, but that will be difficult if they are consolidated under some other, composite or virtual, device. I tried running HID Demo from a Remote Desktop session, but then it didn't see any devices at all. Any other suggestions? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Input / Output interfaces
Remotes
IR has stopped working
Contact us
RSS
Top
Bottom
