home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
General Support
IRSS Suite not learning remote codes
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dwayne Parsons" data-source="post: 1247880" data-attributes="member: 163200"><p>I've attempted setting up the IRSS Suite blaster software and on most attempts it will not learn any codes. On the initial setup attempt I got 0-4 buttons learned from my STB remote and then it just stopped giving me the ability to learn and the notification would just change directly to IR code not learned immediately. Subsequent attempts have got one or two buttons learned and then the same. The last two attempts I've made after uninstalling the app completely and trying it again from a clean install never learns any of my remotes codes. On the last two attempts the notification says it's ready to learn the IR code but it never does and now never goes directly to IR code not learned but it just sits until the learning mode times out. After about half a dozen attempts I've had to give up and ask the community for help.</p><p></p><p>Does anyone have a similar issue and how was it resolved?</p><p>IRSS v1.5.0.62</p><p>win 10 x64</p><p>ehome transceiver</p><p>Pace IPW800 HD IPTV stb</p><p></p><p>I've installed it using both methods one will never work and the other has only given the results mentioned above.</p></blockquote><p></p>
[QUOTE="Dwayne Parsons, post: 1247880, member: 163200"] I've attempted setting up the IRSS Suite blaster software and on most attempts it will not learn any codes. On the initial setup attempt I got 0-4 buttons learned from my STB remote and then it just stopped giving me the ability to learn and the notification would just change directly to IR code not learned immediately. Subsequent attempts have got one or two buttons learned and then the same. The last two attempts I've made after uninstalling the app completely and trying it again from a clean install never learns any of my remotes codes. On the last two attempts the notification says it's ready to learn the IR code but it never does and now never goes directly to IR code not learned but it just sits until the learning mode times out. After about half a dozen attempts I've had to give up and ask the community for help. Does anyone have a similar issue and how was it resolved? IRSS v1.5.0.62 win 10 x64 ehome transceiver Pace IPW800 HD IPTV stb I've installed it using both methods one will never work and the other has only given the results mentioned above. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
General Support
IRSS Suite not learning remote codes
Contact us
RSS
Top
Bottom