Reply to thread

Message

<blockquote data-quote="Stan1w" data-source="post: 1193495" data-attributes="member: 158912">OK, I am still having difficulty getting IRSS to work with my set top box.&nbsp; I have done much since my last post.&nbsp; First I updated to Windows 10, (not that I wanted to, but I wanted to get completely away from Media Center).&nbsp;&nbsp; Then I did a clean install of Win 10.&nbsp; I reinstalled MediaPortal 1.&nbsp; I have everything working, including the guide and all of the channels from my antenna and the cable company. In MediaPortal I can watch and change the terrestrial channels. When I select a cable channel the set top box is selected, but if I change to a different cable channel the same original channel is showing.&nbsp; There is no blaster working to the set top box.&nbsp; I am using a keyboard to make these changes.When I installed IRSS I selected: IR Server, MediaPortal plug in, MP Control plug in and MP Blast Zone Plug in.&nbsp; TV Server Plug Ins, TV Server Blaster Plug in.&nbsp; Tools, Abstractor, Debug Client and Translator.&nbsp; I installed IRSS as an application.In TV Server Configuration I selected Server Blaster and TV3 Blaster plug in.&nbsp; After stopping and starting the service I selected the TV 3 Blaster plug in.&nbsp; My set top box is a Cisco RNG100 from Comcast.&nbsp; This set top box is not listed in the Quick Set up box.&nbsp; I then went to the IR Commands tab to try to input the codes from my set top box remote.&nbsp; Here is where I get stuck.&nbsp; When I click Learn I get an &quot;Learn IR timed out&quot; before I can press any buttons on the remote.I am including MP logs and the IRSS logs.Thanks again for your patience with me.Wayne</blockquote>

[QUOTE="Stan1w, post: 1193495, member: 158912"] OK, I am still having difficulty getting IRSS to work with my set top box. I have done much since my last post. First I updated to Windows 10, (not that I wanted to, but I wanted to get completely away from Media Center). Then I did a clean install of Win 10. I reinstalled MediaPortal 1. I have everything working, including the guide and all of the channels from my antenna and the cable company. In MediaPortal I can watch and change the terrestrial channels. When I select a cable channel the set top box is selected, but if I change to a different cable channel the same original channel is showing. There is no blaster working to the set top box. I am using a keyboard to make these changes. When I installed IRSS I selected: IR Server, MediaPortal plug in, MP Control plug in and MP Blast Zone Plug in. TV Server Plug Ins, TV Server Blaster Plug in. Tools, Abstractor, Debug Client and Translator. I installed IRSS as an application. In TV Server Configuration I selected Server Blaster and TV3 Blaster plug in. After stopping and starting the service I selected the TV 3 Blaster plug in. My set top box is a Cisco RNG100 from Comcast. This set top box is not listed in the Quick Set up box. I then went to the IR Commands tab to try to input the codes from my set top box remote. Here is where I get stuck. When I click Learn I get an "Learn IR timed out" before I can press any buttons on the remote. I am including MP logs and the IRSS logs. Thanks again for your patience with me. Wayne [/QUOTE]

Verification