Reply to thread

Message

<blockquote data-quote="BBQ rules" data-source="post: 96153" data-attributes="member: 20767">Hi all,I had a well functioning 0.2.0.4 setup when for some reason MP refused to start up again. I did a clean XP install and decided to go for the 0.2.1.0 version and noticed many improvements as to TV picture and movie quality on my CRT TV. One thing didn't turn out to be be an improvement for me, which is the use of the remote.When MP autostarts when XP starts, I can only move the cursor one position forward and one position back. This means that when Basic home displays, I can move from radio to movies and back, but cannot get to TV, which is displayed top center and third in line. Mouse work fine and then there's no problem at all, but that is not why I got myself a remote.I noticed that in the setup program, there are no buttons to be mapped in the config part for the MCE remote, could this be coincidence?What I would like to know is if anybody is experiencing the same problem and has found a solution to this (maybe specific) problem.Hope to hear from you soon.Rgds,Stefan</blockquote>

[QUOTE="BBQ rules, post: 96153, member: 20767"] Hi all, I had a well functioning 0.2.0.4 setup when for some reason MP refused to start up again. I did a clean XP install and decided to go for the 0.2.1.0 version and noticed many improvements as to TV picture and movie quality on my CRT TV. One thing didn't turn out to be be an improvement for me, which is the use of the remote. When MP autostarts when XP starts, I can only move the cursor one position forward and one position back. This means that when Basic home displays, I can move from radio to movies and back, but cannot get to TV, which is displayed top center and third in line. Mouse work fine and then there's no problem at all, but that is not why I got myself a remote. I noticed that in the setup program, there are no buttons to be mapped in the config part for the MCE remote, could this be coincidence? What I would like to know is if anybody is experiencing the same problem and has found a solution to this (maybe specific) problem. Hope to hear from you soon. Rgds, Stefan [/QUOTE]

Verification