Hello gentlemen,
As my title says, only arrows and OK button works with my MCE remote.
I read all I found about this and tried to :
- Reinstall the Mapping XML files from the Default folder
- uncheck the MCE option, reboot, recheck, reboot in the config tool
- using the original MCE remote instead of the Harmony
To be complete in my explaination, here are some facts.
- The Antec internal IR receiver in unplugged.
- The other buttons works great within WMP or WMC
- This same setup worked great until MP 1.2.3 upgrade
- I'm stuck with this problem for days, please, help me
So, I think you have the same knowledge oh the problem than me.
Please, help a poor guy fighting this remote issue
Best regards from Belgium,
JC
PS : I didn't provide logs because I din't show anything, as I can see. If you think it is helpfull, I will add them.
As my title says, only arrows and OK button works with my MCE remote.
I read all I found about this and tried to :
- Use another user profile (as suggested by Paranoid Delusion here)
- Uninstall and reinstall MediaPortal- Reinstall the Mapping XML files from the Default folder
- uncheck the MCE option, reboot, recheck, reboot in the config tool
- using the original MCE remote instead of the Harmony
To be complete in my explaination, here are some facts.
- The Antec internal IR receiver in unplugged.
- The other buttons works great within WMP or WMC
- This same setup worked great until MP 1.2.3 upgrade
- I'm stuck with this problem for days, please, help me
So, I think you have the same knowledge oh the problem than me.
Please, help a poor guy fighting this remote issue
Best regards from Belgium,
JC
PS : I didn't provide logs because I din't show anything, as I can see. If you think it is helpfull, I will add them.