home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
General Support
MCE Remote to Control STB
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jwolf" data-source="post: 29592" data-attributes="member: 17405"><p>I have been configuring MP and setting up my PVR for about 6 weeks now and I finally am able to capture the output of my set-top box, but I am unable to control the box using my MCE remote. Yes, I have programmed the volume and on buttons, but how do I control all the functions of the box using the remote? I know this question has definitely been answered, but I was unable to find any information. </p><p></p><p>I have tried using HIP, but I am unsure how to configure sending IR signals to my STB. I have also tried using the USBIRT page in the set-up, but I get an error for each button I am asked to press (likely due to the fact that I don't know where to download the drivers). If someone knows of a method to essentially, press each and every key on the STB remote and teach them accordingly to the MCE remote, please advise. Thank you.</p></blockquote><p></p>
[QUOTE="jwolf, post: 29592, member: 17405"] I have been configuring MP and setting up my PVR for about 6 weeks now and I finally am able to capture the output of my set-top box, but I am unable to control the box using my MCE remote. Yes, I have programmed the volume and on buttons, but how do I control all the functions of the box using the remote? I know this question has definitely been answered, but I was unable to find any information. I have tried using HIP, but I am unsure how to configure sending IR signals to my STB. I have also tried using the USBIRT page in the set-up, but I get an error for each button I am asked to press (likely due to the fact that I don't know where to download the drivers). If someone knows of a method to essentially, press each and every key on the STB remote and teach them accordingly to the MCE remote, please advise. Thank you. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
General Support
MCE Remote to Control STB
Contact us
RSS
Top
Bottom