Reply to thread

Message

<blockquote data-quote="nick_w79" data-source="post: 856053" data-attributes="member: 121927">Thanks for the reply Ray.&nbsp;I tried to use IRSS but found it completely unfathomable and couldn't find any real guide on how to use it.&nbsp;I had a look at the log files though to see if I could make any sense and I noticed an error when updating an XML file called &quot;Hauppauge HCW&quot;. I had a look at this file in Notebook and saw that the remote config was getting the x10 codes from there. I thought that if I entered the x10 codes manually then the remote should work. I thought I found the codes on another forum where someone was having a similar problem. They had listed hex codes for each key so I initially tried those with no luck, and then tried the decimal equivalent, also with no luck.&nbsp;I'm no expert but I suspect I may be on the right track.&nbsp;Is there any software which could tell me which x10 codes my remote is sending to the receiver?</blockquote>

[QUOTE="nick_w79, post: 856053, member: 121927"] Thanks for the reply Ray. I tried to use IRSS but found it completely unfathomable and couldn't find any real guide on how to use it. I had a look at the log files though to see if I could make any sense and I noticed an error when updating an XML file called "Hauppauge HCW". I had a look at this file in Notebook and saw that the remote config was getting the x10 codes from there. I thought that if I entered the x10 codes manually then the remote should work. I thought I found the codes on another forum where someone was having a similar problem. They had listed hex codes for each key so I initially tried those with no luck, and then tried the decimal equivalent, also with no luck. I'm no expert but I suspect I may be on the right track. Is there any software which could tell me which x10 codes my remote is sending to the receiver? [/QUOTE]

Verification