Reply to thread

Message

<blockquote data-quote="akajammer" data-source="post: 886929" data-attributes="member: 127877">After opening dxdiag, the green process bar gets to 80% and displays a pop-up:&quot;DxDiag has detected that there may have been a problem accessing Directshow the last time this program was used. Would you like to bypass DirectShow this time?&nbsp; [yes]&nbsp; [no]&quot;&nbsp;I select [no], the process continues for a minute more, then another pop-up:&quot;Data Execution Prevention. To help protect your computer, Windows has closed this program. Name: MS Dx Diag Tool. [change settings]&nbsp; [close message].&quot;&nbsp;I select [change settings].Two options present,The 2nd option: &quot;Turn on DEP for all programs and services except those I select&quot;&nbsp;&nbsp; is selected.Two items are unchecked.....MS DX Diag Tool &amp; Windows Explorer.&nbsp;No changes were made, I selected [cancel], then a pop-up appears that MS DX Diag Tool encountered a problem, etc, etc.Three options present [debug] [send report] [do not send report].I select [debug],&nbsp; DX Diag closes. Not sure where the debug file went?&nbsp;I did run dxdiag again, but this time left the first pop-up and moved it to the side and was able to navigate around in the program.I can not find anything obvious, or anything regarding directshow.There was an option to [save all information], I selected this option but the 'collecting information' pop-up get to about 35%, stating its collecting directshow information and does not seem to process any further(pop-up periodically flickers like its trying to compile the information). I let it process for about an hour before I closed it out.&nbsp;filmerit screen shot attached.Yes, I always restart anytime a change is made.&nbsp;thank you for the super fast reply!&nbsp;jammer</blockquote>

[QUOTE="akajammer, post: 886929, member: 127877"] After opening dxdiag, the green process bar gets to 80% and displays a pop-up: "DxDiag has detected that there may have been a problem accessing Directshow the last time this program was used. Would you like to bypass DirectShow this time? [yes] [no]" I select [no], the process continues for a minute more, then another pop-up: "Data Execution Prevention. To help protect your computer, Windows has closed this program. Name: MS Dx Diag Tool. [change settings] [close message]." I select [change settings]. Two options present, The 2nd option: "Turn on DEP for all programs and services except those I select" is selected. Two items are unchecked.....MS DX Diag Tool & Windows Explorer. No changes were made, I selected [cancel], then a pop-up appears that MS DX Diag Tool encountered a problem, etc, etc. Three options present [debug] [send report] [do not send report]. I select [debug], DX Diag closes. Not sure where the debug file went? I did run dxdiag again, but this time left the first pop-up and moved it to the side and was able to navigate around in the program. I can not find anything obvious, or anything regarding directshow. There was an option to [save all information], I selected this option but the 'collecting information' pop-up get to about 35%, stating its collecting directshow information and does not seem to process any further(pop-up periodically flickers like its trying to compile the information). I let it process for about an hour before I closed it out. filmerit screen shot attached. Yes, I always restart anytime a change is made. thank you for the super fast reply! jammer [/QUOTE]

Verification