MP Scan Problem (1 Viewer)

[moryoav]

Hi all...

I used to use the built-in TV Plugin and everything worked fine. All the TV Channels were scanned and found properly. I then switched to use the new engine TV Server and now there's a few channels whose reception is really bad now.
When I used to use the built-in TV Plugin I could see the frequency of each channel and now using the TV-server I can't see the frequencies (and therefore I cannot change them, or fine-tune them).

Is there a way to see the frequencies? What should I do? Why is there a problem now?


Thank you...


Yoav.

 

[Paranoid Delusion]

In TVServer config\channels, select a channel you have problem with, right click and select edit, this will bring up a screen with the relevant tuning details under different tabs, select your card type, all the details are there.

What type of card are you having problems with, ie make\model, part of the world\region you are scanning, transmitter if known would help too.

 

[moryoav]

Hi, thank you for replying.
I know how to right-click on a channel, but then I see that all the channels have a frequency of 0Mhz (Auto mode) and I cannot see the underlying frequency (and therefore I cannot change it or finetune it).
The card is Hauppauge PVR-150 and the country is Israel. A TV that's also connected in my house has no problems and the built-in TV plugin I had before I installed the TV server also worked 100% fine (I could see all the frequencies there, unlike now).

What should I do...?

Thanks...

 

[Doron]

Hot analog radio frequencies

Hot analog TV frequencies