MP vs. Cyberlink PowerCinema (1 Viewer)

[architect]

Hi,
I bought a TV card ASUS My Cinema P7131 Hybrid. I instaled Asus last drivers and bundled software (PowerCinema). PowerCinema works fine but I want a MP! PowerCinema cooperate with MCE RC really excelent. I think this is a problem. How can I deactivate autorun (when I insert DVD or CD) which lunch PowerCinema? How can I deactivate a PowerCinema without uninstall.

 

[trisixnine]

you can do this in a PowerCinema settings, you should decide to do not run film when insert the disk.

Now, could you give me what have you done to solve the problem of scanning channel for TV (analogic or cable channels)?

Bye!

 

[architect]

I will try it. Is this setting in PowerCinema enviroment or exist a special configuration utility?

My card tuned correctly all chanels from Cable without my help. All worked automaticly. I was very surprised because this soft is the first in my life which tuned absoluttely perfect all channels. Picture is very good (Hauppauge HVR-1100 based on the same chipset Philips is little better) and sound clear. I had a little problem with sound. Default audio setting send a sound direct throught PCI bus. Sound was unusable for me because contains a lot of defects and noise segments. I conected audio out from TV card throught a cable direct to a motherboard and... sound is clear like vine.
I dont know to check digital part because I dont know find any digi signal
All this informations descibed PowerCinema not MP!

Back to my problem.
I need to set a PowerCinema to absolutely passive mode. What does mean? Any reaction, when I push a button on remote control. I dont want to activate a TV tuner when I push a LiveTV button. I want to activate this one with MP not with PowerCinema.

Thaks for all advices

 

[trisixnine]

Architect,

I've tried to send a request to a cyberlink, if I have news I send to you...

however, could you suggest me the way to have a better view of TV engine with P7131?
in this moment I've a lot of problem in visualization if I use the Standard MP decoders (like MPVDecoder and DscalerDecoder) I see the image but not fluent instead if I use a Cybertec MPEG decoder I see the image but with a continuously flashing, can you give me some information about the correct set-up to use it?

Regarding the sound, I haven't any problem, but I use AC3 codec and it's really good to listen TV.

P.S.: actually I use the last version of MP.

 

[MelDi]

I need to set a PowerCinema to absolutely passive mode. What does mean? Any reaction, when I push a button on remote control. I dont want to activate a TV tuner when I push a LiveTV button. I want to activate this one with MP not with PowerCinema.

I managed to do stop PowerCinema responding to the remote by editing the "IRremote.ini" file that resides in the "C:\windows" directory and putting a semicolon in front of any line refering to WinTV2k.exe or Powercinema.exe. In theory you could reprogram the file to do other functions, but I use Eventghost instead to monitor and launch programs.

Hope that helps