Hey,
I have the following setup
Acer X243HQ (DVI) and Samsung 40" LCD TV (VGA) plugged into my HTPC (Nividia 8600GT) Both running at 1920x1080
The acer monitor is a new addition and I have set it up to clone the image (Cheap TV in the bedroom!)
The problem is that on the TV now has an image tearing issue. If I disable cloning it all works fine again. I've updated to the latest nvidia drivers but still no luck, made sure aero was turned on and also tried changing the interlacing settings in MP.
I think it might be due to the face I only have a 50hz tv, even though in the nvidia control panel it does say it's running at 60.
Any Suggestions?
If I can't get a fix in clone mode, I was thinking there might be a workaround, is it possible to run MP on both monitors at the same time while not in clone mode?
I have the following setup
Acer X243HQ (DVI) and Samsung 40" LCD TV (VGA) plugged into my HTPC (Nividia 8600GT) Both running at 1920x1080
The acer monitor is a new addition and I have set it up to clone the image (Cheap TV in the bedroom!)
The problem is that on the TV now has an image tearing issue. If I disable cloning it all works fine again. I've updated to the latest nvidia drivers but still no luck, made sure aero was turned on and also tried changing the interlacing settings in MP.
I think it might be due to the face I only have a 50hz tv, even though in the nvidia control panel it does say it's running at 60.
Any Suggestions?
If I can't get a fix in clone mode, I was thinking there might be a workaround, is it possible to run MP on both monitors at the same time while not in clone mode?