home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
General Support
need help for slave tv server install, and diseqc not working
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mm1352000" data-source="post: 876888" data-attributes="member: 82144"><p>Hi again</p><p> </p><p>There doesn't seem to be any obvious problem with sending DiSEqC commands for the KNC tuner. The Omicom tuner is not sending DiSEqC commands at all - MP TV Server does not yet support DiSEqC for Omicom tuners.</p><p> </p><p>You seem to be testing only with manual scans, so I am struggling to figure out which satellites are on each port:</p><p>port 1 = Astra 28.2E or Hotbird 13E?</p><p>port 2 = ?</p><p>port 3 = Eutelsat 5W?</p><p>port 4 = ?</p><p> </p><p>When you scan, I strongly recommend that you set the inner FEC rate. Also, if you're scanning DVB-S2 transponders use modulation "QPSK" for DVB-S2 QPSK and "8 PSK" for DVB-S2 8 PSK.</p><p> </p><p>mm</p></blockquote><p></p>
[QUOTE="mm1352000, post: 876888, member: 82144"] Hi again There doesn't seem to be any obvious problem with sending DiSEqC commands for the KNC tuner. The Omicom tuner is not sending DiSEqC commands at all - MP TV Server does not yet support DiSEqC for Omicom tuners. You seem to be testing only with manual scans, so I am struggling to figure out which satellites are on each port: port 1 = Astra 28.2E or Hotbird 13E? port 2 = ? port 3 = Eutelsat 5W? port 4 = ? When you scan, I strongly recommend that you set the inner FEC rate. Also, if you're scanning DVB-S2 transponders use modulation "QPSK" for DVB-S2 QPSK and "8 PSK" for DVB-S2 8 PSK. mm [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
General Support
need help for slave tv server install, and diseqc not working
Contact us
RSS
Top
Bottom
