Reply to thread

Message

<blockquote data-quote="Lotsofjazz" data-source="post: 1213307" data-attributes="member: 64243">Thanks! I used the &quot;add /Configure DB to the TV server shortcut&quot; method to get it working again...well at least TV serversetup opens, but now a second problem appears..A bit weird though.. the Computername was correct all the time, but after setting the IP to a fixed IP on the fritzbox and filling out the IP address instead of the computername in the MySQL connect to database panel, and changed the name of the database (allmost forget that) that took care of TV server setup working again..But now that second problem.. Scanning of channels now fails.. I used the tuningparameters I posted here myself and have been using previously with great succes. But when selecting the tuning parameters and click Scan, very quickly all frequencies show somethimng like &quot;Scanning failed, no signal&quot;. I must say I have updated the drivers for the Digital Devices cards (yes 64mbit type), maybe I should not have done that.In windows 10 device manager, it shows the DD cards are working fine (no yellow or red exclamation marks).Also the DD setup utility works fine (turning tuners on/off, check the smart card, etc)..Anyway.. MP keeps me busy again, I will remove everything again, including MySQL and the database, and start from scratch.. will let you know if that works.</blockquote>

[QUOTE="Lotsofjazz, post: 1213307, member: 64243"] Thanks! I used the "add /Configure DB to the TV server shortcut" method to get it working again...well at least TV serversetup opens, but now a second problem appears.. A bit weird though.. the Computername was correct all the time, but after setting the IP to a fixed IP on the fritzbox and filling out the IP address instead of the computername in the MySQL connect to database panel, and changed the name of the database (allmost forget that) that took care of TV server setup working again.. But now that second problem.. Scanning of channels now fails.. I used the tuningparameters I posted here myself and have been using previously with great succes. But when selecting the tuning parameters and click Scan, very quickly all frequencies show somethimng like "Scanning failed, no signal". I must say I have updated the drivers for the Digital Devices cards (yes 64mbit type), maybe I should not have done that. In windows 10 device manager, it shows the DD cards are working fine (no yellow or red exclamation marks). Also the DD setup utility works fine (turning tuners on/off, check the smart card, etc).. Anyway.. MP keeps me busy again, I will remove everything again, including MySQL and the database, and start from scratch.. will let you know if that works. [/QUOTE]

Verification