Reply to thread

Message

<blockquote data-quote="discoian" data-source="post: 75507" data-attributes="member: 23845">Hi,Thanks for your answer.&nbsp; Is it absolutely imperitive the following is setup?---You have to have some method of changing the STB using IR. MP can learn your existing codes from your STB remote and duplicate them.Can you see regular FTA channels on MP? If so then this will rule out some sort of Codec issue.You also have to map the inputs. IE Tell MP that video input 1 matches audio input 1 or whatever is the case in your set up.---All i'm doing is taking an analogue feed from my STB, so I don't need IR control.&nbsp; I don't use the DVB side therefore I cannot confirm if I can see the FTA channels or not.Incidentally, now if I try to use MP, I just get an error message which says &quot;The Tuners Are Busy&quot; - so now I cannot use it at all.&nbsp; However, the installed Hauppage software works a treat.Maybe I should re-install MP and see what happens.</blockquote>

[QUOTE="discoian, post: 75507, member: 23845"] Hi, Thanks for your answer. Is it absolutely imperitive the following is setup? --- You have to have some method of changing the STB using IR. MP can learn your existing codes from your STB remote and duplicate them. Can you see regular FTA channels on MP? If so then this will rule out some sort of Codec issue. You also have to map the inputs. IE Tell MP that video input 1 matches audio input 1 or whatever is the case in your set up. --- All i'm doing is taking an analogue feed from my STB, so I don't need IR control. I don't use the DVB side therefore I cannot confirm if I can see the FTA channels or not. Incidentally, now if I try to use MP, I just get an error message which says "The Tuners Are Busy" - so now I cannot use it at all. However, the installed Hauppage software works a treat. Maybe I should re-install MP and see what happens. [/QUOTE]

Verification