Reply to thread

Message

<blockquote data-quote="azzuro" data-source="post: 1142488" data-attributes="member: 50482">from [USER=82144]@mm1352000[/USER]&nbsp; explanationHi chrikIt is good if your provider(s) constantly move your channels to different frequencies. When you enable the option, TV Server uses the following logic:0. Scan finds a channel.1. Check: do we already know about a channel with this network ID + service ID combination?- if YES, update the existing tuning details- if NO, create a new channelThe default logic (when you don't enable the option) is only slightly different:0. Scan finds a channel.1. Check: do we already know about a channel with this network ID + transport stream ID + service ID combination?- if YES, update the existing tuning details- if NO, create a new channelThe option won't work for everyone (as we found out in MP 1.2.0b) because some providers have different channels with the same network ID + service ID combination. In those cases, the provider differentiates between the two channels using the transport stream ID. That is technically bad behaviour by the providers, but it caused so much trouble when we added and enabled the option by default in MP 1.2.0b that we have changed the wording and disabled it by default in 1.2.0rc.Hope that makes sense attachFull166635</blockquote>

[QUOTE="azzuro, post: 1142488, member: 50482"] from [USER=82144]@mm1352000[/USER] explanation Hi chrik It is good if your provider(s) constantly move your channels to different frequencies. When you enable the option, TV Server uses the following logic: 0. Scan finds a channel. 1. Check: do we already know about a channel with this network ID + service ID combination? - if YES, update the existing tuning details - if NO, create a new channel The default logic (when you don't enable the option) is only slightly different: 0. Scan finds a channel. 1. Check: do we already know about a channel with this network ID + [B]transport stream ID[/B] + service ID combination? - if YES, update the existing tuning details - if NO, create a new channel The option won't work for everyone (as we found out in MP 1.2.0b) because some providers have different channels with the same network ID + service ID combination. In those cases, the provider differentiates between the two channels using the transport stream ID. That is technically bad behaviour by the providers, but it caused so much trouble when we added and enabled the option by default in MP 1.2.0b that we have changed the wording and disabled it by default in 1.2.0rc. Hope that makes sense attachFull166635 [/QUOTE]

Verification