PC does not enter standby with MP 1.7 (1 Viewer)

[bart0190]

Hi,
I recently upgraded from MP 1.5 to MP 1.7.
With MP 1.5 the system entered standby by itself after recording and/or the defined time in powerscheduler. Manually sending the system to standby also worked.

After upgrading to MP 1.7 I can manually send the system to standby and wake it up, but it does not do it after recording anymore. When I try to send the system to standby manually (e.g. in the morning) after recording it does not accept/execute the command. Other commands from the remote are accepted.

Does anyone have an idea what the reason could be or what I could try to check?
I have attached 2 zip files with the logs where a recording was done at night and the system did not enter standby.

thanks
bart

 

[bart0190]

Any ideas?

Regards
bart

 

[Luca Brasi]

What does your sys say when you type powercfg /requests in an admin cmd in this situation?

 

[bart0190]

Thanks for the reply. Please find attached the powercfg output.
First screenshot is after it didn't enter standby.
2nd: After this I pressed the power off button on my remote and right away entered powercfg command.
3rd: Wait a certain time and entered powercfg again.

thanks
bart

 

[Luca Brasi]

Please check this...
https://forum.team-mediaportal.com/threads/pc-wont-go-to-standby.122776/page-2#post-1064673