Reply to thread

Message

<blockquote data-quote="tangmonster" data-source="post: 251156" data-attributes="member: 40621">Hi , my older 478 mother board also has the exact same issue with my new mce remote.The only way i got it to work was by not going into S3 standby but setting it in the bios to only use s1 standby.Yes the cpu and other fans runs all the time and basically only hdd's and screen is switched off ,but this is the only way i could get it to work.i think the older motherboards just don't support switching off wake up from usb . because there is no such setting in my bios.S0/Working&nbsp; &nbsp; &nbsp; System is on. The CPU is fully up and running; power conservation is on a per-device basis.S1 Sleep&nbsp; &nbsp;&nbsp; System appears off. The CPU is stopped; RAM is refreshed; the system is running in a low power mode.S2 Sleep&nbsp; &nbsp;&nbsp; System appears off. The CPU has no power; RAM is refreshed; the system is in a lower power mode than S1.S3 Sleep (Standby)&nbsp; &nbsp;&nbsp; System appears off. The CPU has no power; RAM is in slow refresh; the power supply is in a reduced power mode. This mode is also referred to as 'Save To RAM'.S4 Hibernate&nbsp; &nbsp;&nbsp; System appears off. The hardware is completely off, but system memory has been saved as a temporary file onto the harddisk. This mode is also referred to as 'Save To Disk'.S5/Off&nbsp; &nbsp;&nbsp; System is off. The hardware is completely off, the operating system has shut down; nothing has been saved. Requires a complete reboot to return to the Working state.</blockquote>

[QUOTE="tangmonster, post: 251156, member: 40621"] Hi , my older 478 mother board also has the exact same issue with my new mce remote. The only way i got it to work was by not going into S3 standby but setting it in the bios to only use s1 standby. Yes the cpu and other fans runs all the time and basically only hdd's and screen is switched off ,but this is the only way i could get it to work. i think the older motherboards just don't support switching off wake up from usb . because there is no such setting in my bios. S0/Working System is on. The CPU is fully up and running; power conservation is on a per-device basis. S1 Sleep System appears off. The CPU is stopped; RAM is refreshed; the system is running in a low power mode. S2 Sleep System appears off. The CPU has no power; RAM is refreshed; the system is in a lower power mode than S1. S3 Sleep (Standby) System appears off. The CPU has no power; RAM is in slow refresh; the power supply is in a reduced power mode. This mode is also referred to as 'Save To RAM'. S4 Hibernate System appears off. The hardware is completely off, but system memory has been saved as a temporary file onto the harddisk. This mode is also referred to as 'Save To Disk'. S5/Off System is off. The hardware is completely off, the operating system has shut down; nothing has been saved. Requires a complete reboot to return to the Working state. [/QUOTE]

Verification