Pinnacel 300i analogue again... (1 Viewer)

[tuds47]

Hi
I have a problem with my pinnacle 300i and mediaportal. I can not make it show channels in analogue mode, but I think it might wotk with digital but since there is no digital signals where I live it is kind of hrad to test. After searching the forum I can see that other have had a simular problam, an would just like to know if the analogue part of the 300i has been supported in the mean time or if there is a possible work around to make it work?
The software that comes with the 300i is so crappy, and the mediaportal software looks so nice, so I truely hope that my card is supported... otherwise I would have to buy a new card

Regards
Thorbjørn

 

[tuds47]

Hi again...
I might should have played a little more around with the software before asking the question... sorry...
The solution to use the Analogue part of the Pinnacel 300i is to add the analogue capture card in the Setup program. By default only the digital part will show up...

I still have a problem with the sound that I have not figuered out...

Regards
Thorbjørn

 

[spanner2006]

pinnacle analog audio

try pluging in a cd audo cable form the pinnacle card to the motherbourd CD-IN.