Pinnacle pctv 310i (1 Viewer)

[pierremenard]

I'm not at home, so I don't have the specs of my pc, but this should be irrilevant.

I have the tv tuner in subject, pinnacle pctv310i. In fullscreen, when I switch from analog tv to dvbt channels I get a "no signal" error. So I have to exit fullscreen and I have to turn off and than turn on tv (I mean with the button in "my tv").

When I use the "channel" button in "my tv" -so I change channel not in fullscreen- this error does not occur.

Moreover, if the last tv channel seen is analogue, autotune in setup does not work: it passes through transponders without hanging on any frequencies.

Thank you!

F.

 

[floppydonkeyste]

Pinnacle 310i

Hi,

I'm having a similar problem. Media Portal finds any digital station from my pinnacle 310i but is unable to use the analgue side of the card. It comes up with error

"Unable to create graph for this device"

I don't get a good digital signal so I have to rely on analogue. So I'm stuck with pinnacle media centre (inferior to Media Portal)

Can someone please help

Stephen

 

[pierremenard]

Re: Pinnacle 310i

Hi,

I'm having a similar problem. Media Portal finds any digital station from my pinnacle 310i but is unable to use the analgue side of the card. It comes up with error

"Unable to create graph for this device"

Stephen

Have you installed any software mpeg encoder (not decoder) as intervideo or cyberlink?

You need it in order to see analogue channels

F.

 

[Dado]

Supported?

Hi all,
Is this board (PINNACLE PCTV Hybrid Pro PCI 310i) fully supported by MediaPortal?

I mean DVB-T, analogue TV, Radio, Digital Radio, DivX recording and (not important ) Mce ?

I want to buy this board for Dvb-T because I have Hauppauge Pvr-350 now that don't supports Dvb-T and DivX recording....


Thanks a lot,
Dado

 

[pierremenard]

Re: Supported?

Hi all,

I want to buy this board for Dvb-T because I have Hauppauge Pvr-350 now that don't supports Dvb-T and DivX recording....

Divx recording?
Unfeatured option

F.

 

[Sergi Pinyol]

Try using the driver 3xHybrid.sys version 1.3.3.1 downloaded from Terratec site
(PTV 380 WHQL Driver). Simply replace the file and reboot.