Reply to thread

Message

<blockquote data-quote="cadams8221218" data-source="post: 992135" data-attributes="member: 131421">Ok. Here is the complete rundown.&nbsp; how to setup hauppauge colossus with npvri have ir server suite setup supposedly so i can use my hp windows media center remote, i learned the ir codes for my remote for my cable box, i used these exact instructionsTo easily setup IRSS 1.4.2.3496...1) Open the installer. During the setup, leave the default stuff checked but also check the boxes in front of...- Under Tools, &quot;Keyboard Input Relay&quot;.- Under CommandLine Tools, &quot;IR Blast&quot; and &quot;Hauppauge PVR Tuner&quot;.2) After the installer finishes, the configuration for IR Server will appear. I have a Microsoft MCE device so I clicked on the CONFIGURE button for it. On the KEYBOARD tab, check the box in front of &quot;Enable keyboard input&quot;. Click OK then OK again. The IR Server service will restart.3) Now go to START &gt; ALL PROGRAMS &gt; IR SERVER SUITE &gt; TRANSLATOR to open Translator.- Check the box in front of &quot;Start Translator with Windows&quot;.- On the IR Commands tab, learn your STB codes for buttons 0-9.- Click OK.4) Open NPVR and go to SETTINGS.- Open DEVICES &gt; YOUR CARD- Set the Executable to C:\Program Files (x86)\IR Server Suite\IRBlast.exe- Set the Arguments to -host localhost -channel {channel} -delay 350That's it. IRSS 1.4.2.3496 works just fine.Ok. I have npvr playing live tv. When I try to change the channel I c the numbers come up and after I hit the third and last digit the led on the ir receiver blinks 3 times. I've never seen that b 4. But the channel doesn't change.&nbsp; What am I DoIng wrong? I'm usin an Hp external blaster and remote. Wmc kind and am running windows 7 32 bit</blockquote>

[QUOTE="cadams8221218, post: 992135, member: 131421"] Ok. Here is the complete rundown. how to setup hauppauge colossus with npvr i have ir server suite setup supposedly so i can use my hp windows media center remote, i learned the ir codes for my remote for my cable box, i used these exact instructions To easily setup IRSS 1.4.2.3496... 1) Open the installer. During the setup, leave the default stuff checked but also check the boxes in front of... - Under Tools, "Keyboard Input Relay". - Under CommandLine Tools, "IR Blast" and "Hauppauge PVR Tuner". 2) After the installer finishes, the configuration for IR Server will appear. I have a Microsoft MCE device so I clicked on the CONFIGURE button for it. On the KEYBOARD tab, check the box in front of "Enable keyboard input". Click OK then OK again. The IR Server service will restart. 3) Now go to START > ALL PROGRAMS > IR SERVER SUITE > TRANSLATOR to open Translator. - Check the box in front of "Start Translator with Windows". - On the IR Commands tab, learn your STB codes for buttons 0-9. - Click OK. 4) Open NPVR and go to SETTINGS. - Open DEVICES > YOUR CARD - Set the Executable to C:\Program Files (x86)\IR Server Suite\IRBlast.exe - Set the Arguments to -host localhost -channel {channel} -delay 350 That's it. IRSS 1.4.2.3496 works just fine. Ok. I have npvr playing live tv. When I try to change the channel I c the numbers come up and after I hit the third and last digit the led on the ir receiver blinks 3 times. I've never seen that b 4. But the channel doesn't change. What am I DoIng wrong? I'm usin an Hp external blaster and remote. Wmc kind and am running windows 7 32 bit [/QUOTE]

Verification