Post processing settings do not stick (1 Viewer)

[camoura]

I am having this problem since I installed one of the latest SVN (I´ll see which one tonight).

Entering "configuration" I add filters to the DVD post processing settings.

Exit and run media portal. Post processing settings works perfectly.

Run "configuration" again and Post Processing settings are blank !!!

Run media portal and post processing settings are not loaded!

Please help!

 

[FlipGer]

Hi,

well, it would be nice, if you could tel us the SVN version. Perhaps its a bug. It then should be reported here:
https://forum.team-mediaportal.com/0_2_3_0_rc1_and_svn-f206.html

Thanks,
Flip.

 

[camoura]

I've tried SVN 15633 and it has the same problem.

Post processing settings do not show when reentering setup.

Filters added are FFDSHOW RAW VIDEO and NVIDIA VIDEO POST PROCESSOR.

If I add only FFDSHOW RAW VIDEO, it sticks. Adding only NVIDIA VIDEO POST PROCESSOR it also sticks. Adding both neither one sticks.

Perhaps this is not a bug but the way it should be. Am I right?

Thanks

 

[FlipGer]

Hi,

Perhaps this is not a bug but the way it should be. Am I right?

No. You should be able to add as much filters as you like. If this makes sense or not.
Tested it with pure RC1 and there this behaviour ist not shown.
I can confirm this behaviour with Revision:15638. So this is a bug, I think.

Flip.

 

[xvffx]

ARrrghhh... again !

another unfinished discussion

whats the solution ? is it going to be address ?

right now Im just trying to get CC to work from the DVD via post processing (now Im onto graphedit )

all Im just trying to do is 1 step at a time, but 2 weeks on this DVD section alone ?! mind you.. Im not giving up

so.. I should go back to RC1 ?

Vff