Problem Importing Channels (1 Viewer)

mm1352000

Retired Team Member
  • Premium Supporter
  • September 1, 2008
    21,578
    8,228
    Home Country
    New Zealand New Zealand
    Still it's not showing as installed in TVConfig.
    It would require at least a TV Server config restart after installation for the change to be picked up. It may even require a system restart.

    though it appears to have installed under Programs in the Control Panel. I don't suppose that is matters that during the installation it says that it is for XP/Vista, yet I'm on 8.1?
    Sorry, I honestly don't know.

    Maybe I should contact Hauppauge tomorrow?
    I'm not sure that they'd be able to help.
    The other possibility is to try to install the 3rd party encoders from here:
    https://forum.team-mediaportal.com/...l-most-software-encoder-based-tv-cards.90355/
     

    LCF

    New Member
    June 15, 2015
    8
    0
    Home Country
    United States of America United States of America
    I have requested the 3rd party encoders you suggest. If there's anything that I should try in association with Edalex's comment, let me know. Just so weird that WMC is working fine with this tuner!
     

    LCF

    New Member
    June 15, 2015
    8
    0
    Home Country
    United States of America United States of America
    Okay, didn't look far enough into the thread to see it had been reposted after it had been taken down at some point...in any case, the good news is that I seem to be making a bit of progress :). After downloading and installing the 3rd party encoders, I was able to get a signal and scan for channels. I believe it has now found the bulk of the analog channels.
    Now to my next hang up! I opened Media Portal after scanning the channels. If I go to TV and Channels, I can see the channels listed (though randomly, not in numerical order), but when I attempt to turn TV on OR choose one of the channels from the channel list, everything freezes and I have to "Task Manager" to get out. I know I am likely not doing something right here. I have looked a bit at the forums, believe the TV is enabled and such.
    Can you look at the attached log and see anything...or perhaps suggest what I might be doing wrong?

    Getting there, slowly but surely! If I can just get the TV going, I'll attack the guide next...
     

    Users who are viewing this thread

    Top Bottom