Problem with Terratec 2400i and standby modes (1 Viewer)

[Dann]

Well seems that the thing has to be sorted out one way or another. If i would had this problem, i'll try to test the tunner on another system and see if it still happens with the original software and drivers, or will atleast try it on a fresh install of the OS (didn't catch what OS are using any of you) - on the site is mentioned that the tuner supports Win MCE, so it was probably fully tested only with that one... if it still happens on another system with a clean install of Win MCE with the original software and drivers (from the box), the cause is for sure the tunner, otherwise is something else.
Maybe any of you can see an IRQ conflict? (use powerstrip)

Hope anything helps and wish u luck on this one

ps: wish me luck too on finding another HD dual tuner at least as good as this one... they stopped the production of the 2400i DT ... hell they make me suffer like a bi***

Dann

 

[Paranoid Delusion]

they stopped the production of the 2400i DT

Where did you get that from, as no mention of it on the Terratec website, also not in there discontinued range, and been unable to find anything relating to this comment.

Also card still available here from specific retailers.

 

[Dann]

Well, i wish it was still available also in my area but i can't get to another conclusion after a month long search for it and today coming back to this forum and after seeing that poost, what should i think anymore? ..seems that in your area the sellers has it still in stock, so grab one and send it to me please

Dann

 

[Nitram]

Petsa

The only common hardwaredriver we have (exept Terratec) is ATI detonator. I have had the problem with the December driver, and now I'm trying the Februari driver.... "holding my thumbs"

/Martin

 

[romadd64]

Dann

Look at eBay, a german store has a lot of 2400i, bids ends usually under 50€

romadd

 

[petsa]

Hi Nitram,

Any luck with newer drivers from ATI?

/Peter

 

[Nitram]

no luck =(

/Martin

 

[petsa]

This weekend I installed a new 2400i card and it works! So many hours spent on trying to resolve this issue and in the end it was a HW problem...

Now the HTPC resumes happily from S3 standby and myTV works without any problems.

/Peter