Reply to thread

Message

<blockquote data-quote="pannivas" data-source="post: 86302" data-attributes="member: 23174">RadLight is very easy.&nbsp; It’s a program that identifies all your DirectShow Filters.&nbsp; Under DirectShow Filters you can do the following things.1)&nbsp; &nbsp; see all the filters that are installed on your pc2)&nbsp; &nbsp; Open and change the options (if it exists) of the selected Filter3)&nbsp; &nbsp; Set merits on your filters.&nbsp; A higher merit will make the selected filter used over another filter with lower merit. (i.e. you have 2 MPEG2 decoder filters installed on your pc DScaler and PureVideo and you set the PureVideo merit to MERIT_PREFERRED + 1 and the DScaler decoder merit to MERIT_NORMAL then when you playback an MPEG2 file PureVideo will be used over DScaler decoder).4)&nbsp; &nbsp; Unregistered filters that you don’t want.Its better to use graphedit first before changing your filter merits.&nbsp; With graphedit you can open a video file and see which codecs will be used to decode it, both video and audio.&nbsp; If graphedit shows that Dscaler or any other MPEG2 decoder then you have 2 options.&nbsp; i)&nbsp; &nbsp; Either set a higher merit for PureVideo and lower merit for the other MPEG2 decoders.ii)&nbsp; &nbsp; Unregistered all other MPEG2 decoders that you don’t want to use (i.e. DScaler, MPV the ones that come with MP installation bundle)I hope this is helpful enough.</blockquote>

[QUOTE="pannivas, post: 86302, member: 23174"] RadLight is very easy. It’s a program that identifies all your DirectShow Filters. Under DirectShow Filters you can do the following things. 1) see all the filters that are installed on your pc 2) Open and change the options (if it exists) of the selected Filter 3) Set merits on your filters. A higher merit will make the selected filter used over another filter with lower merit. (i.e. you have 2 MPEG2 decoder filters installed on your pc DScaler and PureVideo and you set the PureVideo merit to MERIT_PREFERRED + 1 and the DScaler decoder merit to MERIT_NORMAL then when you playback an MPEG2 file PureVideo will be used over DScaler decoder). 4) Unregistered filters that you don’t want. Its better to use graphedit first before changing your filter merits. With graphedit you can open a video file and see which codecs will be used to decode it, both video and audio. If graphedit shows that Dscaler or any other MPEG2 decoder then you have 2 options. i) Either set a higher merit for PureVideo and lower merit for the other MPEG2 decoders. ii) Unregistered all other MPEG2 decoders that you don’t want to use (i.e. DScaler, MPV the ones that come with MP installation bundle) I hope this is helpful enough. [/QUOTE]

Verification