Reply to thread

Message

<blockquote data-quote="misterd" data-source="post: 291846" data-attributes="member: 19503">The new quality control is completely different approach and based on standardized interfaces by M$. Since this approach supports more cards and also software encoders we don't know the maximum bitrate. Therefor we query for the maximum bitrate through this interface. You can see the minimum and maximum bitrate in the log. It should look like:[code]analog: Encoder BitRate Min 65536 Max 80000000 Delta 1024[/code]The values are in bps.It seems that the drivers of hauppauge don't tell us the exact value. We don't have any influence on these values and can't do anything. AFAIK the best results are normally with setting &quot;high&quot; and &quot;variable bit rate peak&quot;With the old quality control, which was also used in the old MP, it was possible, but those values are in the code and we have to set it to a value which is good for all users (stuttering). This old quality control will perhaps be configurable after the 1.0 release, but I don't know right yet.MisterD</blockquote>

[QUOTE="misterd, post: 291846, member: 19503"] The new quality control is completely different approach and based on standardized interfaces by M$. Since this approach supports more cards and also software encoders we don't know the maximum bitrate. Therefor we query for the maximum bitrate through this interface. You can see the minimum and maximum bitrate in the log. It should look like: [code] analog: Encoder BitRate Min 65536 Max 80000000 Delta 1024 [/code] The values are in bps. It seems that the drivers of hauppauge don't tell us the exact value. We don't have any influence on these values and can't do anything. AFAIK the best results are normally with setting "high" and "variable bit rate peak" With the old quality control, which was also used in the old MP, it was possible, but those values are in the code and we have to set it to a value which is good for all users (stuttering). This old quality control will perhaps be configurable after the 1.0 release, but I don't know right yet. MisterD [/QUOTE]

Verification