Reply to thread

Message

<blockquote data-quote="Fab55" data-source="post: 1268856" data-attributes="member: 61176">Hi,hope somebody can help.I changed two things at once:1. Upgraded from Mediaportal 1.23 to 1.242. Upgraded from HD-TV connected via VGA to 4K-TV connected via HDMI.In the past I got the sound directly from the PC, now it goes through HDMI to TV.My problem:Every time after standby, when I start a recording, I see a black picture for about 2 sec. (with no sound), then it goes back in tv recordings screen.When start the recording the second time, it runs normally. When I start another recording after that, it runs normally.This behaviour is new. I know, changing 2 things at one time is always not an good idea.But does anybody know something about this problem?By the way, the automatic refersh rate change is still switched off...Used renderer is EVR. Filters are LAV filters.Thanks and best regardsFab55</blockquote>

[QUOTE="Fab55, post: 1268856, member: 61176"] Hi, hope somebody can help. I changed two things at once: 1. Upgraded from Mediaportal 1.23 to 1.24 2. Upgraded from HD-TV connected via VGA to 4K-TV connected via HDMI. In the past I got the sound directly from the PC, now it goes through HDMI to TV. My problem: Every time after standby, when I start a recording, I see a black picture for about 2 sec. (with no sound), then it goes back in tv recordings screen. When start the recording the second time, it runs normally. When I start another recording after that, it runs normally. This behaviour is new. I know, changing 2 things at one time is always not an good idea. But does anybody know something about this problem? By the way, the automatic refersh rate change is still switched off... Used renderer is EVR. Filters are LAV filters. Thanks and best regards Fab55 [/QUOTE]

Verification