home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
'RT News' not showing up in channel scan
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mm1352000" data-source="post: 988262" data-attributes="member: 82144"><p>Yeah, I understand that. The problem is that it is possible that RT is carried on more than one satellite. So at least knowing which satellite(s) you're looking at is critical. Additionally, if you have a DiSEqC switch in the loop then it is possible that copying somebody else's settings will not work.</p><p> </p><p></p><p>Now that I can see you're receiving from 28.2e, here are the basic settings for RT HD:</p><p> </p><p>Frequency = 11224000 kHz</p><p>Polarisation = vertical</p><p>Modulation = not set</p><p>Symbol Rate = 27500</p><p>Inner FEC rate = 2/3</p><p>Pilot = not set</p><p>Roll Off = not set</p><p>Service ID = 53148</p><p>Network ID = 2</p><p>Transport Stream ID = 2312</p><p>PMT PID = 0</p><p>Free To Air = ticked</p><p>Provider = <anything you like></p><p>DiSEqC = <depends on your setup></p><p> </p><p>FYI:</p><p><a href="http://en.kingofsat.net/pos-28.2E.php" target="_blank">http://en.kingofsat.net/pos-28.2E.php</a></p><p> </p><p>mm</p></blockquote><p></p>
[QUOTE="mm1352000, post: 988262, member: 82144"] Yeah, I understand that. The problem is that it is possible that RT is carried on more than one satellite. So at least knowing which satellite(s) you're looking at is critical. Additionally, if you have a DiSEqC switch in the loop then it is possible that copying somebody else's settings will not work. Now that I can see you're receiving from 28.2e, here are the basic settings for RT HD: Frequency = 11224000 kHz Polarisation = vertical Modulation = not set Symbol Rate = 27500 Inner FEC rate = 2/3 Pilot = not set Roll Off = not set Service ID = 53148 Network ID = 2 Transport Stream ID = 2312 PMT PID = 0 Free To Air = ticked Provider = <anything you like> DiSEqC = <depends on your setup> FYI: [url]http://en.kingofsat.net/pos-28.2E.php[/url] mm [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
'RT News' not showing up in channel scan
Contact us
RSS
Top
Bottom