Scanning for channels (1 Viewer)

[SCHED7]

Hi,

First post so treat me nicely.

I installed MP for the first time last night. I'm using a DVico Dual 4 and during the initial setup, I managed to only get 3 channels from the setup scan. Having got all the other channels using the Fusion software, I know there isn't a problem with my reception. How do I go about doing a manual scan? My initial searches have come up with nothing.

Thanks

 

[Sheldon]

Hi, I've got the same query. I'm using v0.2.2.0 and ran through the wizard briefly with no antenna connected now I can't find the screen to rescan for channels.
How can I re-run the initial setup wizard?

 

[HighQ]

I believe if you go into settings the wizard is right there

 

[ronilse]

Hi, I've got the same query. I'm using v0.2.2.0 and ran through the wizard briefly with no antenna connected now I can't find the screen to rescan for channels.
How can I re-run the initial setup wizard?

Hi
Use the one in MP Setup (Configuration) -> Television -> Capture Cards & Edit your card + auto tune.

Regards
Roy

 

[Sheldon]

you guys are quick, I just found this out for myself. Thanks
By the way if I go through settings wizard from within Media Portal it crashes the application. I read that this is due to the analogue card being installed.

 

[ronilse]

you guys are quick, I just found this out for myself. Thanks
By the way if I go through settings wizard from within Media Portal it crashes the application. I read that this is due to the analogue card being installed.

Hi,
Yup it's a known bug in Mantis, but not fixed yet.

Regards
Roy