Server not found upon resume of client (1 Viewer)

[ulischultz]

In a multi-seat setup, with the server running continuously, when resuming the client from standby with MP client running, the "TV-configuration" screen to enter the server name is displayed, after klick on back, connection to the server is ok again.
Can the check fot the server connection delayed somehow, so that it gives the client some time to re-establish the network connection? See also attached logs.

 

[regeszter]

Hi,

you can configure the delay in the configure.exe.

 

[ulischultz]

Ok, I did that, but if I set the value too high, MP just crashes and if I set it around 5 or 6 sec, it works, but after the delay, MP reverts back to the TV-page with TV off. How can I make MP to get back to the Home-Screen after resume?
The "Show last active module when starting / resuming from standby" option is deselected in the configuration.exe
Thanks!

 

[regeszter]

@Sebastiii is working on the "Show last active module when starting / resuming from standby" bug. You can try his installer in this forum or my installer from here.