Normal
Well, I installed some of the codecs but I think i'm still missing something...In the general section of the tv-server config, it says the ATI and Hauppauge codecs are installed, and I set the priority of them to be at the top. (And only those two codecs.)Yet, when scanning, I still get "No Signal". Unfortunately I do not have any more time today to play with this, but I will keep you posted!P.S. I am using an ATI All-In-Wonder 9000.I think my problem was I did not remove all codecs using codec sniper, as I have over 500 codecs visible. I will have to go thorugh at some point and remove ALL codecs on the system and re-install.(or maybe format pc and install only these codecs.)
Well, I installed some of the codecs but I think i'm still missing something...
In the general section of the tv-server config, it says the ATI and Hauppauge codecs are installed, and I set the priority of them to be at the top. (And only those two codecs.)
Yet, when scanning, I still get "No Signal". Unfortunately I do not have any more time today to play with this, but I will keep you posted!
P.S. I am using an ATI All-In-Wonder 9000.
I think my problem was I did not remove all codecs using codec sniper, as I have over 500 codecs visible. I will have to go thorugh at some point and remove ALL codecs on the system and re-install.
(or maybe format pc and install only these codecs.)
