Reply to thread

Message

<blockquote data-quote="jassmel" data-source="post: 1197551" data-attributes="member: 108763">Hi Sebastiii,i have just found annother Problem which might be rleated to the TVLibrary.dll in context with the Skystar2 using WDM Drivers.It is related to DVB-EPG and burt I think it might not be related to V1.15 only. I tried an downgrade to V1.14 and see the same behavior:It seems that the tickmark &quot;Grab EPG only for channels on the same Transponder&quot; is ignorred using a Skystar2 with WDM dirvers.Only 4 channels should be grabbed, but 79 are grabbed. See log file TVServer.log line 312. This result in incomplete EPG data (only 2 entries)for lot of channels. Using the same EPG Setup with a different TV Card with BDA Drivers (Skystar HD2) works fine. I used that for years without problems.See logfile TVServer6.log line 1665.I tried all kind of different EPG Settings for the SkystarS2 (WDM Driver Card) without success. Many stations have only 2 entries, because if&nbsp; 79 stations with partialinfo (2 entries) are read already with the first Transponder, they will not read again with the correct Transponder.Any idea ? I assume if the tickmark &quot;Grab EPG only for channels on the same Transponder&quot; on the EPG page would be handled correctly it would work.For WDM Card, I don't see any Impact. For BDA Card there is Impact. Unticking for BDA-Card, result in the same wrong misbehavior.</blockquote>

[QUOTE="jassmel, post: 1197551, member: 108763"] Hi Sebastiii, i have just found annother Problem which might be rleated to the TVLibrary.dll in context with the Skystar2 using WDM Drivers. It is related to DVB-EPG and burt I think it might not be related to V1.15 only. I tried an downgrade to V1.14 and see the same behavior: It seems that the tickmark "Grab EPG only for channels on the same Transponder" is ignorred using a Skystar2 with WDM dirvers. Only 4 channels should be grabbed, but 79 are grabbed. See log file TVServer.log line 312. This result in incomplete EPG data (only 2 entries) for lot of channels. Using the same EPG Setup with a different TV Card with BDA Drivers (Skystar HD2) works fine. I used that for years without problems. See logfile TVServer6.log line 1665. I tried all kind of different EPG Settings for the SkystarS2 (WDM Driver Card) without success. Many stations have only 2 entries, because if 79 stations with partial info (2 entries) are read already with the first Transponder, they will not read again with the correct Transponder. Any idea ? I assume if the tickmark "Grab EPG only for channels on the same Transponder" on the EPG page would be handled correctly it would work. For WDM Card, I don't see any Impact. For BDA Card there is Impact. Unticking for BDA-Card, result in the same wrong misbehavior. [/QUOTE]

Verification