I've noticed that two tuners get used on the server, even if it's the same channel selected on the upstairs and downstairs clients. All three systems are Windows 7 clean builds since Christmas, with initial MP install straight to 1.3B.
I've attached clean logs from a TVserver startup. Then I connect with Client 1 and start viewing a channel selected from the guide (clean logs from MP startup). Then I connect with Client 2 and select the same channel from the guide. Two tuners are in use on the server afterwards. I stop Client 2, and then go to the TV section and select Active Streams and select the one active stream that Client 1 is using. After a delay, a second tuner gets allocated on the server and starts streaming to Client 2 instead of showing Client 1's stream (clean logs from MP startup).
I'm pretty sure it didn't used to do this on older versions. This would cause out of tuner errors in my house on some occassions, if two live sessions are occuring, while multiple recordings are going on.
I've attached clean logs from a TVserver startup. Then I connect with Client 1 and start viewing a channel selected from the guide (clean logs from MP startup). Then I connect with Client 2 and select the same channel from the guide. Two tuners are in use on the server afterwards. I stop Client 2, and then go to the TV section and select Active Streams and select the one active stream that Client 1 is using. After a delay, a second tuner gets allocated on the server and starts streaming to Client 2 instead of showing Client 1's stream (clean logs from MP startup).
I'm pretty sure it didn't used to do this on older versions. This would cause out of tuner errors in my house on some occassions, if two live sessions are occuring, while multiple recordings are going on.