tuning and installation questions (1 Viewer)

[zorzini]

Dear sirs,
first of all thanks for your job...now I have two questions:

1) I installed MP on a new XP sp3 PC equipped with Hauppauge HVR4000 hybrid board:
if I do a complete scan DVBS DVBT and analogue channels will be correctly recognized but nothing appears in the chanell list for DVBT in MP server configuration and also in MP only analogue and DVBS channells are present.

2) After the installation few satellite chanells have video or audio problems like: video freezed at first frame, audio not present or very bad (like donald duck); I installed ffdshow changed the settings in video / audio codecs section.
I tested this bad channels both by MP Server configuration preview and from MP program.

3) I decided to try a new XP and MP installation; could be a good idea to install only the Hauppauge board drivers plus the remote driver and not the complete suite (including Cyberlink PowerCinema) ?

Thanks a lot for your help.

Ok, I answer myself at the missing DVBT missing channels question:
Probably I have to group the tuners into hybrid group inside MP server...tonight I will test...

bye

 

[zorzini]

Ok...finally I found a solution for point 2 in my previous post...I applied the suggestion founded in a post

I changed in ffdshow audio decoder configuration MP1,MP2 from libmad to libavcodec and now audio and video are perfectly decoded ;

Also is not necessary to re-install again XP (point 3).

Tomorrow I will try to solve the point 1 (DVBT channells fond by scan but not exposed in MP) by testing grouping hybrid cards infos and suggestions.

Thanks for your attention