TV Card problem (1 Viewer)

[Paul S]

Thank you for the information. But, the information is better if it comes from GraphEdit. I think the device ID is OK, but I still need the filter names from GraphEdit. Just the ones that are for your card.

 

[antoniomch]

I hope this is the missing info.
A made a screen shot of the graphedit

TV Card WDM Video Capture
@devicenp:\\?\pci#ven_1131&dev_7130&subsys_01385168&rev_01#4&3b1d9ab8&0&4040#{65e8773d-8f56-11d0-a3b9-00a0c9223196}\global
TV Card Tuner
@devicenp:\\?\stream#lvtuner#5&38f1b993&0&0#{a799a800-a46d-11d0-a18c-00a02401dcd4}\global
TV Card CrossBar
@devicenp:\\?\pci#ven_1131&dev_7130&subsys_01385168&rev_01#4&3b1d9ab8&0&4040#{a799a801-a46d-11d0-a18c-00a02401dcd4}\global

 

[Paul S]

Thank you, I almost have everything needed. There is one more thing, you will need a MPEG 2 Encoder. Intervideo and Cyberlink are two that I have heard of. I believe that you can get the Cyberlink encoder as a free trial.

Here's a link to the wiki with MPEG encoder info:
http://wiki.team-mediaportal.com/UserGuides/SW-Cards_setup

 

[antoniomch]

I now have instaled the MainConcept Mpeg Encoder

 

[Paul S]

Add the MainConcept MPEG 2 video and audio encoders to the graph and post a picture of it.

 

[antoniomch]

I was having some trouble with MainConcept, I do not know why. Because when I tryed to pass into the graph the Audio encoder he asked me for a file...
Well.... I have now the intervideo installed and I've inserted into the graph de audio and video encoders.

 

[Paul S]

I am having some trouble in figuring out the correct filter set up. I have only set up one analog card, my ATI AIW 9600 pro. It has another filter, for audio. Do you have another filter for your card?
I will post my graph as an example. Try to connect the pins on your graph, to see what happens.

 

[Paul S]

In reviewing other cards that are using the Intervideo encoders, I see a InterVideo Multiplexer listed. Do you have one of these available? If so add it to the graph and try to connect the pins.

 

[antoniomch]

I'm still trying to connect the audio of the "TV Card TV Tuner" with "TV Card Cross Bar"... I've searched again for other filters in the list about this TV Card but with no sucess... Here is a screenshot of graphedit showing what I have now in the graph

 

[Paul S]

Try connecting the tuner audio pin to the TV Crossbar pin #3 Audio Tuner In. For the Capture outputs try connecting Capturar to the Intervideo Video Encoder, and the either the Pre-visualizer or VBI pin to the Intervideo Audio encoder (try both).

Also try connecting the audio out from the tuner directly to the capture filter.

I don't think you need those two ht filters.

Also, you can right click some filters and open the properties page. Then, adjust the settings that you need to adjust.