Reply to thread

Message

<blockquote data-quote="bermag" data-source="post: 324806" data-attributes="member: 55301">Thank you for replying.Can you give any advice how to track down what is causing this? Log file says signal strength/quality is 100 but I am not sure if that is reliable information. Can you give any example of what might cause TS packets to be dropped?Anyway if it is a bad signal should really TV Server crash because of that? Shouldn't it just report &quot;bad signal&quot; or something? Do you think there might be a problem with the card? I know there have been some faulty Terratec 2400i cards. The strange thing is that it might work for a long time but then suddenly it crashes. I left MP runnign for 8 hours or so without any problems (however it was showing same channel so the problems might be related to channel switching). The Terratec software seems to run fine (not sure if it use BDA drivers though). Any test program you can run to test if the crad and/or drivers are working properly? Next thing to try is to make a clean XP installation from start. I think that is the only thing I haven't tried yet.</blockquote>

[QUOTE="bermag, post: 324806, member: 55301"] Thank you for replying. Can you give any advice how to track down what is causing this? Log file says signal strength/quality is 100 but I am not sure if that is reliable information. Can you give any example of what might cause TS packets to be dropped? Anyway if it is a bad signal should really TV Server crash because of that? Shouldn't it just report "bad signal" or something? Do you think there might be a problem with the card? I know there have been some faulty Terratec 2400i cards. The strange thing is that it might work for a long time but then suddenly it crashes. I left MP runnign for 8 hours or so without any problems (however it was showing same channel so the problems might be related to channel switching). The Terratec software seems to run fine (not sure if it use BDA drivers though). Any test program you can run to test if the crad and/or drivers are working properly? Next thing to try is to make a clean XP installation from start. I think that is the only thing I haven't tried yet. [/QUOTE]

Verification