home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
Two issues: Blue screen of Death and No TV Signal
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Donald J. Michaud" data-source="post: 1156909" data-attributes="member: 155049"><p>I deleted the gentle.config file like you requested. I rebooted my PC. I loaded MP1 and it still does the same thing. The "TV ON" is not active, and I cannot select any channels for viewing.</p><p>I went into the MP Configuration app to make sure that The TV open turns on upon start-up and it is active. (see below).[ATTACH=full]170611[/ATTACH]</p><p>Now, when I go to save the setting in MP Configuration, I get an error message:</p><p>[ATTACH=full]170612[/ATTACH]</p><p>Now what do I do? I hope I do not need to uninstall and re-install... This was very painful to get it to this point... Please advise...[DOUBLEPOST=1445175129][/DOUBLEPOST]Is MP2 less problematic? Should I be looking at re-building everything in MP2?</p></blockquote><p></p>
[QUOTE="Donald J. Michaud, post: 1156909, member: 155049"] I deleted the gentle.config file like you requested. I rebooted my PC. I loaded MP1 and it still does the same thing. The "TV ON" is not active, and I cannot select any channels for viewing. I went into the MP Configuration app to make sure that The TV open turns on upon start-up and it is active. (see below).[ATTACH=full]170611[/ATTACH] Now, when I go to save the setting in MP Configuration, I get an error message: [ATTACH=full]170612[/ATTACH] Now what do I do? I hope I do not need to uninstall and re-install... This was very painful to get it to this point... Please advise...[DOUBLEPOST=1445175129][/DOUBLEPOST]Is MP2 less problematic? Should I be looking at re-building everything in MP2? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
Two issues: Blue screen of Death and No TV Signal
Contact us
RSS
Top
Bottom
