United States of America
card=asus pe9400
media portal version=1rc2
location=north carolina, united states
problem= when i scan for atsc channels in the server config section all i get is "physical channel: XX frequency: -1modulation: mod8vsb: no signal" (where XX is a channel number) i can scan ntsc channels and pick them up fine, i can go another tv with a converter box and a big unidirectional antenna (the same that i am using to try to tune with media portal) and get a crystal clear picture. when i am scanning for atsc channels i do not have the tune qam box checked. my signal level is about 3/4 full and my signal quality is about 1/16th full. i do not see any options to change that would tell it to scan in another way. after looking around for a little while on the forums i do not see any prominent post adressing this issue. ive run out of ideas any help would be appreciated. i am sorry in advance if this is a noob issue and i am just being blind or dumb about it.
media portal version=1rc2
location=north carolina, united states
problem= when i scan for atsc channels in the server config section all i get is "physical channel: XX frequency: -1modulation: mod8vsb: no signal" (where XX is a channel number) i can scan ntsc channels and pick them up fine, i can go another tv with a converter box and a big unidirectional antenna (the same that i am using to try to tune with media portal) and get a crystal clear picture. when i am scanning for atsc channels i do not have the tune qam box checked. my signal level is about 3/4 full and my signal quality is about 1/16th full. i do not see any options to change that would tell it to scan in another way. after looking around for a little while on the forums i do not see any prominent post adressing this issue. ive run out of ideas any help would be appreciated. i am sorry in advance if this is a noob issue and i am just being blind or dumb about it.