Reply to thread

Message

<blockquote data-quote="thinksnow" data-source="post: 186997" data-attributes="member: 11265">With 2.3 RC2, I've got a different set of mis-mapped channels, all still in the 2-11 range while 12-99 report fine.Channel 2 is goodChannel 3 is goodChannel 7 shows what is listed for 4Channel 4 shows what is listed for 5Channel 9 shows what is listed for 6Channel 11 shows what is listed for 7Channel 8 is goodChannel 6 shows what is listed for 9Channel 5 shows what is listed for 10Channel 10 shows what is listed for 11I've got some channels now, though, that show a brief flash of tv, then go to static. I'm tempted to swap out the PVR-500 for my PVR-250 just to troubleshoot and ensure that it's not the new card (in addition to switching from XMLTV to YahooTV to Schedules Direct, I switched to the PVR-500 two weeks ago, too). I figure the less variables I'm dealing with, the better, right?<a href="http://pastebin.team-mediaportal.com/pastebin.php?show=13068" target="_blank">epg.log uploaded</a>Edit to add:I tried re-mapping the channels via the configuration screen and all that did was move them in the tvguide, so now the listings show in this order:237491186510but they still display the same program information (i.e., NBC 4 still lists golf, but it is still showing the TVGuide channel, which is channel ). So it would seem that changing the &quot;Channel&quot; under MediatPortal - Setup --&gt; Television --&gt; TV Channels --&gt; Edit properties of TV channel does nothign but move the listing physically.Next stop- manually changing the frequency under the Analog tab.That did it: I had to manually change the frequencies.</blockquote>

[QUOTE="thinksnow, post: 186997, member: 11265"] With 2.3 RC2, I've got a different set of mis-mapped channels, all still in the 2-11 range while 12-99 report fine. Channel 2 is good Channel 3 is good Channel 7 shows what is listed for 4 Channel 4 shows what is listed for 5 Channel 9 shows what is listed for 6 Channel 11 shows what is listed for 7 Channel 8 is good Channel 6 shows what is listed for 9 Channel 5 shows what is listed for 10 Channel 10 shows what is listed for 11 I've got some channels now, though, that show a brief flash of tv, then go to static. I'm tempted to swap out the PVR-500 for my PVR-250 just to troubleshoot and ensure that it's not the new card (in addition to switching from XMLTV to YahooTV to Schedules Direct, I switched to the PVR-500 two weeks ago, too). I figure the less variables I'm dealing with, the better, right? [URL="http://pastebin.team-mediaportal.com/pastebin.php?show=13068"]epg.log uploaded[/URL] [b]Edit to add:[/b] I tried re-mapping the channels via the configuration screen and all that did was move them in the tvguide, so now the listings show in this order: 2 3 7 4 9 11 8 6 5 10 but they still display the same program information (i.e., NBC 4 still lists golf, but it is still showing the TVGuide channel, which is channel ). So it would seem that changing the "Channel" under [b]MediatPortal - Setup --> Television --> TV Channels --> Edit properties of TV channel[/b] does nothign but move the listing physically. Next stop- manually changing the frequency under the [b]Analog[/b] tab. [i]That did it: I had to [U]manually change [/U]the frequencies.[/i] [/QUOTE]

Verification