Reply to thread

Message

<blockquote data-quote="mm1352000" data-source="post: 1102655" data-attributes="member: 82144">HelloYour tuner is failing to start streaming with a generic error code:Since this is a generic error code it could be caused by a variety of things which are really only known to the people who created the tuner driver (ie. for your card, probably only Hauppauge engineers). Most often I've seen it when people try to use tuners straight after Windows startup or resume before the tuner driver is fully ready. In fact the Nova T/DT is quite notorious for this.According to the log files the tuners were both working at 5:52 pm on the 29th. The TV service was stopped and restarted for some unknown reason between 5:54:55 and 5:55:43, and the error started immediately after that when you first tried to use the tuner at ~5:57:[2014-09-29 17:57:41,756] [Log&nbsp; ] [27&nbsp; ] [INFO ] - dvb:&nbsp; RunGraph returns: 0x8007001FTo resolve I suggest you try restarting the TV service:<ol>
<li data-xf-list-type="ol">Open TV Server configuration.</li>
<li data-xf-list-type="ol">Go to the manual control section.</li>
<li data-xf-list-type="ol">Click stop service... then start service.</li>
</ol>If that doesn't help then try restarting the PC. I'd be very surprised if that doesn't get rid of the problem.As for preventing this from happening again: the only thing I can suggest is to increase the tuner detection delay.<a href="http://wiki.team-mediaportal.com/1_MEDIAPORTAL_1/141_Configuration/TV-Server_Configuration/06_General#Delay_for_TV_card_detection" target="_blank">http://wiki.team-mediaportal.com/1_MEDIAPORTAL_1/141_Configuration/TV-Server_Configuration/06_General#Delay_for_TV_card_detection</a>Anything up to 5 minutes may be required depending on the system, but most commonly it would be 10 to 30 seconds.Regards,mm</blockquote>

[QUOTE="mm1352000, post: 1102655, member: 82144"] Hello Your tuner is failing to start streaming with a generic error code: Since this is a generic error code it could be caused by a variety of things which are really only known to the people who created the tuner driver (ie. for your card, probably only Hauppauge engineers). Most often I've seen it when people try to use tuners straight after Windows startup or resume before the tuner driver is fully ready. In fact the Nova T/DT is quite notorious for this. According to the log files the tuners were both working at 5:52 pm on the 29th. The TV service was stopped and restarted for some unknown reason between 5:54:55 and 5:55:43, and the error started immediately after that when you first tried to use the tuner at ~5:57: [2014-09-29 17:57:41,756] [Log ] [27 ] [INFO ] - dvb: RunGraph returns: 0x8007001F To resolve I suggest you try restarting the TV service: [LIST=1] [*]Open TV Server configuration. [*]Go to the manual control section. [*]Click stop service... then start service. [/LIST] If that doesn't help then try restarting the PC. I'd be very surprised if that doesn't get rid of the problem. As for preventing this from happening again: the only thing I can suggest is to increase the tuner detection delay. [url]http://wiki.team-mediaportal.com/1_MEDIAPORTAL_1/141_Configuration/TV-Server_Configuration/06_General#Delay_for_TV_card_detection[/url] Anything up to 5 minutes may be required depending on the system, but most commonly it would be 10 to 30 seconds. Regards, mm [/QUOTE]

Verification