Reply to thread

Message

<blockquote data-quote="Paranoid Delusion" data-source="post: 343052" data-attributes="member: 13176">Have you got recording folder not set too root of drive, ie C:\ is wrong, should be C:\Recorded TV or whatever you wish to name the folder, also make sure all cards point to the same folder, I even have a seperate timeshifting folder inside the main recorded TV one.If already set up like above, then set a delay before detecting cards within TVServers general tab.If you then go into standby (powerscheduler) and then resume with remote, can you tune into channels in TVServer config, if you can, make sure both tuners are starting up, the only way i have found to check this is to rescan the channels on both cards, if any show red then card not being seen, stopping and restarting the TVServer should resolve, if it does you may need to investigate MPStandbyHandler.And are you really on RC2 <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile&nbsp; &nbsp; :)" loading="lazy" data-shortname=":)" /></blockquote>

[QUOTE="Paranoid Delusion, post: 343052, member: 13176"] Have you got recording folder not set too root of drive, ie C:\ is wrong, should be C:\Recorded TV or whatever you wish to name the folder, also make sure all cards point to the same folder, I even have a seperate timeshifting folder inside the main recorded TV one. If already set up like above, then set a delay before detecting cards within TVServers general tab. If you then go into standby (powerscheduler) and then resume with remote, can you tune into channels in TVServer config, if you can, make sure both tuners are starting up, the only way i have found to check this is to rescan the channels on both cards, if any show red then card not being seen, stopping and restarting the TVServer should resolve, if it does you may need to investigate MPStandbyHandler. And are you really on RC2 :) [/QUOTE]

Verification