home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
General Support
Volume not responding after Dolby Digital
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="HTPCSourcer" data-source="post: 378940" data-attributes="member: 74879"><p>Hello hjbaard,</p><p></p><p>You need to have a PCM audio stream in order to control its volume through MP. Hence it may well be a setting issue in ffdshow or - more likely - your "incriminated" audio source is not PCM but something better like Dolby Digital or even DTS.</p><p></p><p>My recommendation would be to </p><p>1. completely forget about the volume setting of MP. Instead you configure your remote in a way that it only controls the receiver. Volume balance between Digital and PCM can then be done once in MP where you adjust the level of a PCM source in a way that it has the same volume level as the otherwise unadjustable digital or DTS source.</p><p>2. set up MP in a way that it decodes ALL sources to SPDIF.</p><p></p><p>Regards, HTPC_Sourcer</p></blockquote><p></p>
[QUOTE="HTPCSourcer, post: 378940, member: 74879"] Hello hjbaard, You need to have a PCM audio stream in order to control its volume through MP. Hence it may well be a setting issue in ffdshow or - more likely - your "incriminated" audio source is not PCM but something better like Dolby Digital or even DTS. My recommendation would be to 1. completely forget about the volume setting of MP. Instead you configure your remote in a way that it only controls the receiver. Volume balance between Digital and PCM can then be done once in MP where you adjust the level of a PCM source in a way that it has the same volume level as the otherwise unadjustable digital or DTS source. 2. set up MP in a way that it decodes ALL sources to SPDIF. Regards, HTPC_Sourcer [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
General Support
Volume not responding after Dolby Digital
Contact us
RSS
Top
Bottom