Reply to thread

Message

<blockquote data-quote="pannivas" data-source="post: 85557" data-attributes="member: 23174">i had the same problem and since i couldnt find any solution or support answer i made a fresh install of Win MCE and MP and all the codecs i needed. But before doing so i installed RadLight Filter manager and set the PureVideo codec merit to the highest and still no luck.&nbsp; I checked my 1080i HD material with GraphEdit what codecs is going to use and it showed me PureVideo but still MP refused to use PureVideo.And now after the fresh install a new problem of the same issue arrised to me again.&nbsp; I have a problem with an h264 HD movie which instead of using CoreAVC to decoded it as graphedit shows me as MCE and WMP does, MP is using PureVideo.You might also try and unregister MPV decoder with RadLight Filtermanager.&nbsp; Then open you .ts file in graphedit and see which codec is now using.&nbsp; If another codec other than PureVideo is been used then put your purevideo merit up if that dosent help unregister the MPEG2 decoder that is been shown under graphedit.&nbsp; That helped me with my Vista test pc.Anyway i really dont understand how this works or how it can happen but hopefully a portal developer will give some answers how we can fix this.&nbsp; Maybe the fix is not within MP or maybe it is i just dont know that.But a possible solution answer would be great.P.S.I wish there was a way to set the codecs you wish to use with certain encoding formats from the MP Setup.&nbsp; And i wish we could force codecs in MP.</blockquote>

[QUOTE="pannivas, post: 85557, member: 23174"] i had the same problem and since i couldnt find any solution or support answer i made a fresh install of Win MCE and MP and all the codecs i needed. But before doing so i installed RadLight Filter manager and set the PureVideo codec merit to the highest and still no luck. I checked my 1080i HD material with GraphEdit what codecs is going to use and it showed me PureVideo but still MP refused to use PureVideo. And now after the fresh install a new problem of the same issue arrised to me again. I have a problem with an h264 HD movie which instead of using CoreAVC to decoded it as graphedit shows me as MCE and WMP does, MP is using PureVideo. You might also try and unregister MPV decoder with RadLight Filtermanager. Then open you .ts file in graphedit and see which codec is now using. If another codec other than PureVideo is been used then put your purevideo merit up if that dosent help unregister the MPEG2 decoder that is been shown under graphedit. That helped me with my Vista test pc. Anyway i really dont understand how this works or how it can happen but hopefully a portal developer will give some answers how we can fix this. Maybe the fix is not within MP or maybe it is i just dont know that. But a possible solution answer would be great. P.S. I wish there was a way to set the codecs you wish to use with certain encoding formats from the MP Setup. And i wish we could force codecs in MP. [/QUOTE]

Verification