X10 Medion Remote Control not working with Rev12364 (2 Viewers)

[diehard2]

I can reproduce it now. I'll work on it over the next couple of days.

 

[diehard2]

This will be fixed in tomorrow's svn. Sorry for the inconvenience. Please post back here and let me know if it works.

 

[DJ Randall]

Great! The SVN of 1.00 hours now gives me a working Remote!

Thx Diehard for the effort!

 

[dorijan]

weeee...it works again

 

[nordlicht_68]

Hi guys,

i have a little trubble with the remote crontrol but now it´s work!

But its no work when you have a clean 0.2.2 and you don´t configured this after the installation an install the cvs. (this way is from the manual)

When you install the clean 0.2.2 an configure the medion remote and activated the both settings option and than you install the cvs, than its work!


many thanks and
happy new year to 2007

 

[diehard2]

It should work just from the svn.

Just a heads up, I'm changing this section of the code again to implement x10 learning. So, if anything breaks, please reply to this thread (since I'm already watching it)

 

[DJ Randall]

Sure, no problem!

 

[nordlicht_68]

Hi,

sorry, but this problem is not resolved (or i make a mistake ,-)

when i configure the medion remote in a clean 0.2.2. i can use them in this version or in a newest cvs from 4.01.07, too.
But when i disable the remote in the configuration.exe (for a test) in next start from the config, the config said: "no driver installed"

i hope diehard found here a problem!

thanks
sTEPHAN

 

[backslash]

Hi,

sorry, but this problem is not resolved (or i make a mistake ,-)

when i configure the medion remote in a clean 0.2.2. i can use them in this version or in a newest cvs from 4.01.07, too.
But when i disable the remote in the configuration.exe (for a test) in next start from the config, the config said: "no driver installed"

i hope diehard found here a problem!

thanks
sTEPHAN

I have same issue here. Once disabled x10 remote in the setup menu i couldn't enable it anymore because of "missing driver".

backslash

 

[diehard2]

fixed in the today's svn