Reply to thread

Message

<blockquote data-quote="x4mer" data-source="post: 237218" data-attributes="member: 59800">Picked up the switch tonight.&nbsp;Just finished the testing. I'm using a 4x1 diseqc with LNBs currently only connected to ports 2 &amp; 3.&nbsp;I loaded up MyTheatre &amp; used it to pick a channel from the LNB on port 3. This then left the switch set for port 3 after closing MT. I then loaded up TVE3 (17406), set the diseqc settings to match MT, &amp; ran the scan for that LNB. Once done, I used MT to switch the switch to port 2 &amp; relaunched TVE3 to scan in the LNB on port 2.&nbsp;With the switch left set for port 2, I then cleared the logs, &amp; used TVE3 to preview a CH on port 3. This didn't work, as the switch never switched to port3. See first log archive.&nbsp;I then cleared the logs, &amp; used TVE3 to pick a CH on port 2, which worked, since that's where the switch was left by MT. See 2nd log archive.&nbsp;I closed TVE3, used MT to switch the switch to port 3. Relaunced TVE3, cleared the logs, &amp; selected the same channel I did the first time. This then worked, after having changed the switch with MT. See 3rd log archive.&nbsp;On an unrelated note (I'm assuming) why do the logs show an ATSC/QAM tuner detected?&nbsp;I've seen this in the logs for some time &amp; it's had me wondering. I only have a DVB-S card, &amp; have never even owned an ATSC card.</blockquote>

[QUOTE="x4mer, post: 237218, member: 59800"] Picked up the switch tonight. Just finished the testing. I'm using a 4x1 diseqc with LNBs currently only connected to ports 2 & 3. I loaded up MyTheatre & used it to pick a channel from the LNB on port 3. This then left the switch set for port 3 after closing MT. I then loaded up TVE3 (17406), set the diseqc settings to match MT, & ran the scan for that LNB. Once done, I used MT to switch the switch to port 2 & relaunched TVE3 to scan in the LNB on port 2. With the switch left set for port 2, I then cleared the logs, & used TVE3 to preview a CH on port 3. This didn't work, as the switch never switched to port3. See first log archive. I then cleared the logs, & used TVE3 to pick a CH on port 2, which worked, since that's where the switch was left by MT. See 2nd log archive. I closed TVE3, used MT to switch the switch to port 3. Relaunced TVE3, cleared the logs, & selected the same channel I did the first time. This then worked, after having changed the switch with MT. See 3rd log archive. On an unrelated note (I'm assuming) why do the logs show an ATSC/QAM tuner detected? I've seen this in the logs for some time & it's had me wondering. I only have a DVB-S card, & have never even owned an ATSC card. [/QUOTE]

Verification